Wise choice?

[Wolf13]

At the moment my primary gun is my ics m4...
Would it be smart to add a systema hop up unit http://www.airsoftarms.com/Systema-P...te-Hop-up-unit

and the Trigger Master MkII AEG Fire Control
http://www.airsplat.com/Items/AC-UPI-TM-TRIGM.htm

Thank you in advance

[kalnaren]

If it works fine, don't worry about the hop-up.

As for the trigger master, look at the advantages and decide if it's worth going through the installation hassle.

[Wolf13]

the hop up imo isnt very smoothe, and same with the single shot, and since i really never hold down the trigger the three shot burst will be perfect for me

[kalnaren]

Originally Posted by Wolf13

the hop up imo isnt very smoothe,

What do you mean by "smooth"? Are the shots consistent? Is there a big difference between no hop and full hop?

and same with the single shot, and since i really never hold down the trigger the three shot burst will be perfect for me

Well, like I said, decide if the advantages is provides are worth it to you for the cost and installation effort. We can't make that decision for you.

[Wolf13]

i mean the shots seem pretty incosistent and i am using .25s

[CJay]

I've installed 5 of those FET units and trust me - ur gonna mess it up at least once on a V2 mechbox unless ur intimately familliar with them - even then its dicey on the V2 cos u have hugely limited wiring space inside there an they can be tricky with the exess wiring u need to cram in there. I eventually found that u had to really modify the mechbox casing to remove the positioning stubs that held the wires down and even then it was a crazy tight squeeze - however saying that if its a front wired V2 its gonna be alot easier than a rear :-P

Also I'd check a couple things first - if ur using a small type batt it can cause resets on the unit if u use a high torque/speed motor - tried it with a systema magnum and u have no idea the hell it causes. Also i'd switch to deans connectors to allow a more freely flowing current or u may have issues in colder weather with the unit reading the battery as too weak to funtion even if it's fine.

if ur up for a bit of work though i recon its worth it