|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
September 24th, 2009, 14:00
|
#1 |
|
G&P gearbox cylinder
I have a G&P M4 RAS II short and I ordered new front set for it along with a 509mm inner barrel. my question is how i can tell which cylinder i have in my gearbox? i don't see holes, rings ..etc.
|
|
|
|
|
September 24th, 2009, 15:14
|
#2 |
|
If it doesnt have any holes then it's a full cylinder.
Strange that was in a CQB gun though....unless it's not stock parts.
__________________
 Airsoft Sales and Repair/Upgrade Services |
|
|
|
|
September 24th, 2009, 15:30
|
#3 | |
|
Red Wine & Adderall
|
Quote:
Its not uncommon although its not common either...lets just say it happens sometimes. Unfortunately the only real way to know for sure would be to take it apart.
__________________
 "Its only a little bit on fire" |
|
|
|
|
|
September 24th, 2009, 16:40
|
#4 | |
|
Try rotating the cylinder in side the gearbox. You may be lucky and you can see a port. I was told by some HK friends that G&P no longer puts ported cylinders on their new guns.
__________________
Do you know what ruins airsoft? (Chair), (Drama), (Air), (Sugar) softers, filthy casuals --- Quote:
WANTED PTW Receiver PRIME, STG, Factory |
|
|
|
|
|
September 24th, 2009, 21:43
|
#5 |
|
I can't seem to turn the cylinder. Could it be a tapered cylinder? i bought the gun 3 years ago. How hard is it to swap out the cylinder? I have never taken a gearbox apart coz I am afraid something pops out and i can't put it back together. anything to align/adjust after a cylinder job? like motor to gearbox?
|
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
