|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
April 27th, 2019, 03:00
|
#1 |
|
KJW M4 upper receiver problem
Hello there guys,suddenly after the shooting I noticed that my upper receiver started to go upwards a little bit,so I looked at it and it seems that the pin gone completely broken off from the part,so how's that could happen and what's the cheap fix for that ?
 
|
|
|
|
|
April 27th, 2019, 19:51
|
#2 |
|
Are you talking about the pins that hold the upper and lower together or did the block at the back of the upper break off?
|
|
|
|
|
April 28th, 2019, 06:31
|
#3 |
|
Actually this one :
 
|
|
|
|
|
|
April 29th, 2019, 12:12
|
#4 |
|
|
You'll have to re upload your pics. The link is not working on my end.
|
|
|
|
|
April 29th, 2019, 12:20
|
#5 |
|
https://prnt.sc/nhv002
https://prnt.sc/nhv034 Pictures working in my side,but just click on those links to see. |
|
|
|
|
|
April 29th, 2019, 12:26
|
#6 |
|
|
Ok, I had the exact same part break. Long story short you need a new upper receiver. 007 airsoft in Calgary stocks them.
You can run it without that pin by running a ziptie through the trigger guard and then over the top to hold it together buts thats a temporary "up shit creek" solution. |
|
|
|
|
April 30th, 2019, 02:54
|
#7 |
|
So you think that part broke because it was weak or it's just design and will always break ?
|
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
