PTS Griffin Arm. QD Blast Shield to hide end of inner barrel

[Zack The Ripper]

Anyone have experience with the PTS Griffin Armament QD Blast Shield? I'm curious if I could hide the 15mm of the end of my inner barrel inside the inner flash hider. Anyone know?

[Rabbit]

It just clips over your standard A2 type flash hiders like the ones on standard M4's - pretty sure it even comes with an A2 type.

Similar to those KAC suppressors everyone has.

So give or take if your inner barrel doesn't go past your flash hider as it is you should be alright.



I was looking at picking one up myself but it really serves no purpose in airsoft other than cosmetics and I decided a short stubby suppressor of similar size would at least give me that 'thump puff' noise.

[EOD Steve]

PTS Griffin accessories cannot clip onto just any A2 flashhider. It requires a specific thickness of gap between the the flashhider flanges. I had a few Griffin accessories that would clip into none of my "standard" A2 flashhiders.

From my experience, their muzzle devices have an ID greater than the OD of an inner so you should be good.

[Zack The Ripper]

Searching more online it seems it has to be paired with a PTS flash hider.

This said, I'll have to look at their flash hider rather than the shield to determine the outcome of the inner barrel issue.