View Single Post
Old November 7th, 2019, 22:31   #11
Socks
 
Socks's Avatar
 
Join Date: Aug 2012
Quote:
Originally Posted by BobbyDangerous View Post
The Hex screws on the bottom of the RAS by the lower receiver. Loosen them up and pull the barrel out. Should be like the Real LMT.

Spray some silicone oil in there as well. you're just going to have to wiggle it. Was prob assembled fresh and the dust coating on the rail has prob glued with the outer barrel joint..
Ended up blasting it with wd40 and letting it sit for a while. No amount of wiggling could get it loose so I used a hammer and it popped off finally.

Thanks!
Socks is offline   Reply With Quote