I did a zci/siegetek 20:1 build recently that was pretty quiet. Not super quiet like my all shs build on my g36, but I've been having issues finding high torque, low amp draw motors with a straight pinion to try the seigetek pinion. ASM guys tell me I can put a siegetek pinion on a D shaft with some pressfit loctite, but I have not had any luck as it just ends up sliding on the shaft of the shs motor I tried it on.
__________________
I futz with V2s, V3s and V6s. I could be wrong... but probably, most likely not, as far as I know.
|