Airsoft Canada - View Single Post - P90 mag feed issues requiring a smack down

Ratters · March 26th, 2020, 01:08

Thanks "Ohm" let me know how it works. I also used a thin, shim size toothpick sized strip of industrial nylon strapping and super glued it to the front face of the upper body seam. Flat sanded so it would fit to the gap when the upper and lower are together.

I found that this was a flex point in the guns assembly and I didn't like it.

I also used strips of old mountain equip co-op card on both sides of the aeg.

The gaps on the sides that curve. I cut two strips "shims" and slid them in with some flat black 100mph tape and no flex anywhere.

Just avoid running into a tree with it . I can't guarantee it will not flex after that.

March 26th, 2020, 01:08	#7
Ratters Trader rating Join Date: Jul 2003 Location: Vancouver	P90 Thanks "Ohm" let me know how it works. I also used a thin, shim size toothpick sized strip of industrial nylon strapping and super glued it to the front face of the upper body seam. Flat sanded so it would fit to the gap when the upper and lower are together. I found that this was a flex point in the guns assembly and I didn't like it. I also used strips of old mountain equip co-op card on both sides of the aeg. The gaps on the sides that curve. I cut two strips "shims" and slid them in with some flat black 100mph tape and no flex anywhere. Just avoid running into a tree with it . I can't guarantee it will not flex after that. __________________ Can´t sleep. Clowns will eat me!