|
I know some of the parts may just good for some brands. Based on these two new parts installed, there are some points you may check by yourself and see.
Between the new slide and the lower, holding the lower and use other hand to pull the slide up see any gap space? Usually has a bit, remember the space size, then insert the magazine in, once the mag hits the nozzle but before the mag got locked, keep an eye on the space I talked about, slowly push mag up and lock it, have you seen the slide slightly got push up and that's the mag and nozzle tightly sealed is good, and now there should have no up-pull movement between slide and lower. If it still has some allow to to pull the slide up, means the slide may not good fit to TM model. You may have gas escape through ejection port or under the slide.
And also you may check the new hi flow valve if it sits in right? Not to deep in, sometimes.
Like I said, I'm no gun doc but this is the way I do the diagnostic for my airsoft, hope it helps!
__________________
aka Uncle
|