Airsoft Canada - View Single Post

drewroud · September 6th, 2012, 21:40

Once again, thanks for the super response.

I am super busy this week, so I will have to give a more detailed response tomorrow or Saturday, and I will have to reread yours.

I understand the purpose of the hammer bearing now. All it does is give the extra "oomph" so that the hammer can lock down. So essentially it does not have to be a bearing, like the guns zero hammer.

I put two pieces of duct tape on the top of the bbu, three was to many because the gun wouldn't rack smoothly. With two there is just enough clearance.

And what do you know, performance immediately increased.

Compared to the stock performance and efficiency, its at about 3/4 while before it was at about 1/4.

I am assuming this means my mags are sitting to low?

Pictures to come...

September 6th, 2012, 21:40	#70
drewroud Trader rating Join Date: Sep 2012	Once again, thanks for the super response. I am super busy this week, so I will have to give a more detailed response tomorrow or Saturday, and I will have to reread yours. I understand the purpose of the hammer bearing now. All it does is give the extra "oomph" so that the hammer can lock down. So essentially it does not have to be a bearing, like the guns zero hammer. I put two pieces of duct tape on the top of the bbu, three was to many because the gun wouldn't rack smoothly. With two there is just enough clearance. And what do you know, performance immediately increased. Compared to the stock performance and efficiency, its at about 3/4 while before it was at about 1/4. I am assuming this means my mags are sitting to low? Pictures to come...