|
To get the jb weld to act as an adhesive you need it to bite into a surface with striations, just rip a patch where you’re going to glue with a dremel even 1/32 would be fine with that much meat all around the eyelet. PL premium would probably never let go, same as CA with baking soda glass fiber reinforcing, except it may fog the lenses.
Actually I just thought of something more traditional. I could cut out enough material on the inside of the mask so JT goggles flat plane radius can sit inside the mask making the mask an accessory over the goggles. The problem I foresee is that JT already sit super prowed and if not buried deep inside the mask, may look super goofy sitting that much more prowed due to JT bulkiness
^ps when i say i thought of something, i mean freezer thought of something and i developed the idea
Last edited by silent_lemon; November 15th, 2017 at 23:13..
|