Quote:
Originally Posted by turok_t
Either opt out with a smaller bearing or mod your BBU. I only tend to mod parts that I know I can have access to in case if I screw up, but luckily, I didn't.
|
Actually, the 8mm hammer bearing doesn't work with the AIP hammer set. Even the stock hammer bearing can't lock the hammer to the sear. It was a strange discovery.
The interaction point and the measurements between the hammer and sear is a bit "off" than the stock one because of the material it's made out of. It's a bit thicker. That's why the hammer bearing on the AIP set is so huge.
I've installed dozens of these hammer sets alongside the 8mm bearing and they all seem to have the same story. But it may be different from his experience.