Does the Magazine Gasket/Airtight Rubber of Hi-capa magazine works on 1911 magazines?
 

I need to replace the Magazine Gasket/Airtight Rubber on one of my TM spec 1911 magazine, and I was wondering if that part is interchangable between 1911 and Hi-capa.
SA Magazine Airtight Rubber for Marui Hi-Capa GBB
Is this going to work?

Of course I could get this Guarder Airtight Rubber for M1911/Detonics Series
which is specified for 1911, but the molding line looks awful in the picture and I was worried that may cause a problem.

hi capa route buckings will NOT work in a standard 1911a1/meu mag.

The hi capa buckings are to tall and wont allow the feed lips over top.

Its a shame that nineball doesn't make a set of the purple ones for the single stack 1911's... they would be a good upgrade in my oppinion

Thanks!

Are you sure? I have a hicapa rubber in my 1911 mag. Works no problems.

Which brand is that?

Kjw to kjw

maybe im wrong then... i was fairly certain for the TM pistols they were not.. KJW could be different -- my mistake

It won't fit. The Hi-Capa one has two indents to allow a double pin insertion, whereas the 1911 one doesn't have the second indent. I suppose you could just squeeze a pin past, but it will create a bump in the gas flow which will restrict flow a bit.

The only aftermarket one that I know of, is made by Future Energy.