View Single Post
Old May 12th, 2009, 22:48   #1
Join Date: Feb 2008
Location: Brampton
Crane stock on G&G m4a1

So my last post I asked about rewiring my mechbox from front to the back so I could use a crane stock. A new rear switch assembly seem to be the way to go.

Now from looking through tutorials online from various forums, it seems a lot of people had to modify their receivers and/or their stock pipe to facilitate the wires. However, I've seen crane stocks on retailers site, that come with the stock pipe and notched circular plate that I'm guessing holds the pipe to your box. Is this plate notch so you could slip the wiring through the stock pipe? If so has anyone installed a crane stock in this manner? thanks
illusive6296 is offline   Reply With Quote