increasing fps on gbb
on average, gbb pistols usually goes below 350 with green gas. For normal 4.3 hi capa, fps doesnt even reach 300fps. So i have been thinking ways to increase the fps.
the most basic thing that i have found was to have hi flow valve for the mag. but the con is that more gas is used, thus depletes faster.
I have thought about decreasing the width of the inner barrel, so there would be more friction, but that just sounds stupid. on real guns, the bullet would be able to spin so allowing more force. but then we are talking about bbs, and they are round >_>.
i also thought about increasing the area of the intake by decreasing it's volume, but i dont think that it would have any significant changes and the intake might blow up.
so any suggestions?
Last edited by 0wangj4; February 26th, 2009 at 03:58..