View Single Post
Old December 12th, 2007, 12:33   #13
airborne1's Avatar
Join Date: Aug 2007
Location: Calgary, Alberta
Russian is right when you slide the inner barrel and the hop up into the upper receiver the nozzle and hop up do not line up not even close. I have encountered all the above problems with mag wells and buffer tubes before and they are an easy fix. But this is a major issue putting extra stress and the nozzle and cylinder head is not good even if you were to dremel out the upper to raise the hop up away from the mag well ( it is too far in the mag well to line up properly) the barrel could always shift down resulting in a broken nozzle or cylinder head.
It's between them and God it's simply my job to arrange the meeting.

airborne1 is offline   Reply With Quote