View Single Post
Old April 8th, 2015, 20:49   #4
Join Date: Aug 2014
Location: GTA
Send a message via Skype™ to dmitril
DIY, there is nothing difficult about soldering something huge like an aeg motor connector even with an overly powerful iron. I do assume its only the wire thats broken off and the actual pad is still there, if not you might want to think of ways to attach a new pad, soldering might not be the best option in this case.

Edit: Do use common sense, 120W can overheat if you let it, but assuming you keep checking and make sure to start soldering just as it melts solder then you'll be done before you need to worry.

Last edited by dmitril; April 8th, 2015 at 20:56..
dmitril is offline   Reply With Quote