View Single Post
Old June 28th, 2014, 21:37   #39
Join Date: Jul 2011
Location: Ottawa
Originally Posted by volteco View Post
Would it be correct if I say TM P226 and all the clones (KJW, WE) won't fit into serpa as opposed to KWA/KSC P226? I believe the same thing is with M9.
it's a pretty safe bet. the only one I found to fit perfectly was the kwa because it's real steel dimensions.

The TM/KJws are only too wide at the front of the frame from what I recall... all you need to do is take some sand paper to the tight areas and open it up a bit.

Or if you don't care about the paint on your gun, don't bother sanding. It will fit.. it's just tight. Even with the properly fitting pistol, you can see the wear marks on my kwa's slide and front of the frame where it makes contact on the way in and out, it's just less than what would be on the TM.
I futz with V2s, V3s and V6s. I could be wrong... but probably, most likely not, as far as I know.
lurkingknight is online now   Reply With Quote