So without thinking too far into it;
-longer mags with modified 5.56 internals, but the feed lips will be the same distance from the back of the mag so you can use the same cylinder
-'normal' SR25 receiver modified for use with PTW internals
-the outer barrel is going to make up for the length hold the hop chamber closer to the cylinder
that about right? lol
Oh also, Brad had pointed out the gap in the end plate of the MOE grip. Seems you guys are using MIAD end plates on a MOE grip. Since the new motor apparently produces very little heat, will they be revising the grip to use the proper end plates to seal the grip and prevent any crap from getting into the motor?
Tamiya connectors suck.
Originally Posted by swatt13
i never understood why the oil refinery had a brothel... i never see them at the refineries i work at this is bull!