View Single Post
Old June 2nd, 2012, 16:27   #13
Juke16's Avatar
Join Date: Sep 2009
Location: Toronto
If you've got a wall charger, cut off the Tamiya connector with a decent amount of wire connected to it. the wire going into the Tamiya connector is actually two wires fused together, split them apart at the end of what you cut off that doesn't have the connector so about 1 cm of the two wires are seperated from each other. One wire will either be red, or have white markings on it; that end should be the positive wire. Attach the alligator clips to the wires and you now have a Tamiya connector for your charger. If you did this incorrectly, the Imax B6 will tell you that the polarity is mixed and all you have to do is switch the order of which alligator is connected to which wire. I'll post up a picture later on if I have time since these instructions are extremely confusing.
Juke16 is offline   Reply With Quote