View Single Post
Old April 2nd, 2011, 14:51   #15
A Total Bastard
Renegade)'s Avatar
Join Date: Apr 2006
Location: Tottenham, Ontario
Originally Posted by DoctorBadVibez View Post
Lots of good advice here, also, you can drill a small hole using a 2.5m bit in the battery side of the deans connector's poles so you can thread your wire through, then flow solder on it, minimum hassle.
This is a good tip, I totaly forgot to bring up. I did it to my gun with deans and it works great, its also alot easier to wrap the wire around through the hole. Then it holds it in place while you solder.

Make sure you use flux and a fully hot iron, otherwise, you can melt the plastic connector.
Renegade) is offline   Reply With Quote