View Single Post
Old September 2nd, 2009, 23:51   #13
Le Roi des poissons d'avril
FOX_111's Avatar
Join Date: Dec 2003
Location: Terrebonne, Québec
I don't know why you would remove all the oil on a valve before installing it. I'm no techy. All I know is that it will be luber later with silicone oil.

So if it has nothing to do with gluing, leaving a little oil on it will not hurt it's installation IMO. If it's too oiled, then rubbing it off might do. Again, I'm stepping in murky water here.

Vérificateur d'âge: Terrebonne
FOX_111 is offline   Reply With Quote